Bissell 1699, 8910 Before You Clean, Carpet Cleaning, Fill The Water Tank, Pretreating optional

Before You Clean

1.Plan activities to give your carpet time to dry.

2.Move furniture to another area if cleaning an entire room (optional).

3.Thoroughly vacuum area with a dry vacuum cleaner before deep cleaning.

4.Plan your cleaning route to leave an exit path. It is best to begin cleaning in the corner farthest from your exit.

5.Pretreating (optional)

Note: Pretreating is recommended to improve cleaning effectiveness for heavily soiled carpet in high traffic areas such as entryways and hallways.

A.Spray the BISSELL Tough Stain Pre-treat formula onto heavy traffic areas, soiled areas, or stains.

B.Allow to penetrate for at least 3 minutes.

C.Following the instructions below, clean as normal, using the BISSELL ProHeat machine on the High Traffic Setting.

Carpet Cleaning

	9
EXIT	10
11	8
12	7
	1
	6
5	2
	3
	4

ATTENTION:

Some Berber carpets have a tendency to fuzz with wear. Repeated strokes in the same area with an ordinary vacuum or deep cleaner may aggravate this condition. Please see Stain Removal instructions on page 15.

Fill The Water Tank

1.Release the handle and lay the machine handle back to access the Tank.

2. Remove the Tank from the base of the machine by lifting the Tank carry Handle.

3.Carry like a bucket to the sink. Rotate the Handle forward to unlatch the lid. Lift off and set the lid aside.

4.Fill up the Bladder with clean hot tap water.

*Do not boil or microwave water as it can destroy the Bladder.

5.Replace the top of the Tank by matching the lid and tank edges. Handle must be in the forward position in order to replace lid. Rotate the handle to the carrying position to latch the lid.

Note: Remember to secure the lid and test to make sure it is secure before picking up the Tank.

6.Place tank into machine base, seating firmly in place. Rotate tank handle back into latched position. Bring machine handle back into upright position.

Fill The SmartMix/Formula Tank

1.Lift the formula Tank up and out of the machine base.

2.To fill the Formula Tank, first unscrew the Cap and Insert. Always use genuine BISSELL formulas to maximize cleaning and for the safety of your machine. Fill formula up to the line and replace the Cap and Insert. Place Formula Tank back into the base of machine, making sure it is seated securely.

Note: If bottle leaks, check for proper positioning of red gromment and straw.

12

34

56

12

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1 9

ug310-5868_1699_306.indd 9 3/1/06 3:13:49 PM