ENGLISH
4 EN
KS-708HT 1214/02-06/EN
Installation Methods
On Floor or Shelf
Place the speakers on the floor or on a shelf or other
horizontal stable surface. Keep in mind that speakers are
not fixed into place, so be careful to avoid knocking them
over.
On the Wall
The front, center and surround speakers include mount
holes for wall mounting. You can hang the front and
surround speakers on the wall vertically, and the center
speaker horizontally.
For vertical mount, you use only one screw and hang the
speaker from its upper mount hole only. For horizontal
mount, you need to set two screws into the wall at the
appropriate distance so that you can hang the speaker from
both mount holes.
Front speakers, Surround speakers
1. Attach the bracket using
supplied screw.
2Screw a single screw into the wall at the desired
location. Screw it only part way in, so that the screw
projects 12 to 14 mm (1/2 to 9/16 inches) outward from
the wall surface.
2. Hang the speaker by fitting the top mount hole (at the
upper rear of the speaker) over the extending part of
the screw. Confirm that the speaker is held firmly and
securely in place.
Attaching the cushions
Attach cushions to the base of the speaker as shown below.
The cushions prevent the speaker from sliding, and dampen
its vibrations.
On floor or shelf On the wall
Be sure to attach in
the upper hole.
Center speaker
1. Remove the base.
2. Attach the bracket, using screws which are removed
in step 1.
3. Screw two screws into the walls 120 mm (4-3/4 inches)
apart, making sure that screws are horizontally level.
Screw each screw only part way in, so that the screw
projects 12 to 14 mm (1/2 to 9/16 inches) outward from
the wall surface.
4. Hang the speaker by fitting the two mount holes (at
the rear of the speaker) over the extending part of the
screw. Confirm that the speaker is held firmly and
securely in place.
12 - 14 mm
(1/2 - 9/16”)
120 mm
(4-3/4”)
Precautions
Please observe the following precautions when
mounting speakers onto the wall.
•Be sure that the wall you are using is strong enough to
support the full weight of the speaker (approx. 1.1 kg
[2.4 lb]).
•Wall screws must be purchased separately. Be sure to
use screws that are appropriate for the wall you are us-
ing, and that are long enough to provide sufficient
strength.
•If you are uncertain about the wall’s support strength,
the type of screw to use, or any other points regarding
this type of installation, please consult a contractor or
other qualified person before proceeding.
Be sure to follow the procedure given here when
carrying out installation. Kenwood can assume no
liability for injury or damage that may occur if a speaker
setup falls from the wall as a result of incorrect
installation or insufficient support strength.
12 - 14 mm
(1/2 - 9/16”)