Operation
1. Set the crossover frequency.
Turn the LOW PASS FREQUENCY control knob to adjust the balance between the bass from the rear speakers and the bass from this unit as desired.
2.Adjust the low frequency level. Turn the knob to the desired level.
80 100
50150
(Hz)
FREQUENCY
MINMAX
Power indicator
3. Adjust the low frequency phase. | LEVEL | |||
|
|
| ||
The low frequency tone may be variable depending on the |
|
|
| |
position of the unit, its orientation or the crossover frequency. This |
|
|
| |
can be adjusted by changing the position of the PHASE switch. Set | PHASE | |||
this switch to either position according to your liking. | ||||
|
|
| ||
Power Supply/Control Input/Terminal (for
Speaker Cords)
LINE IN terminal (RCA pin jack)
REMOTE terminal
PHASE
FREQUENCY
LEVEL
■Power IndicatorBlue glows | Light is OFF |
[Power ON ] | [Power OFF ] |
Exchange with the specified capacity fuse.
Removal: Grasp with your fingers and pull up.
Insertion: Insert the fuse gently into the fuse holder and push in all the way with your finger.
Fuse
Fuse holder
Replacement fuse 5A
Caution:
Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 5A.
MAX |
| 50Hz |
LEVEL |
| 80Hz |
| 150Hz | |
|
| 100Hz |
MIN |
|
|
LOW | FREQUENCY | HIGH |
3Remote control unit
When connecting the cord, align the jacks as shown below.
REMOTE CONTROL |
Install the remote control unit on the vehicle by the provided Velcro tape.
3Remote control unit
Vehicle
4Velcro tape |
|
|
(Hook surface) | 4Velcro tape | Rear panel |
| ||
| (Loop surface) |
|
Caution:
Install the remote control unit in a position that does not come in the way of driving operations.
Avoid installing it in a place subject to direct sunlight or direct hot wind from the heater.
Remove dirt from the installation position before attaching the Velcro tape.
English 5