Installation
■Mounting the Sirius Satellite radio tuner Unit
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following
2CAUTION
•Install the Sirius satellite radio tuner unit in a
•The Sirius satellite radio tuner unit is equipped with a cooling fan to lower the internal temperature. Do not block the holes of the cooling fan at the time of installation. Blocking the holes of the cooling fan will cease to allow the temperature to be lowered and will cause breakdown.
•When installing to the car, the unit should be securely fastened at a location that will not interfere with driving.
•When making a hole in the chassis, check that the gas tank, break pipe, wire harness, or other part is not located on the other side, and be careful not to cause scratches.
•When attaching the mounting fittings (Accessory2) to the Sirius satellite radio tuner unit, use only the supplied mounting screws (Accessory3) (M4 x 8 mm). Use of screws other than those supplied may result in internal damage or insecure mounting and is very dangerous.
table for possible problems.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
The Sirius mode cannot | The Sirius connection wire is not | Use the Sirius connection wire to |
be selected. | connected. | connect the control unit and the Sirius |
|
| satellite radio tuner. |
|
|
|
| Connect the power supply of the Sirius | Connect the battery wire and ground |
| satellite radio tuner. | wire to the Sirius satellite radio tuner. |
|
|
|
| The PROTOCOL selection switch of the | Set the PROTOCOL selection switch to |
| changer switching unit | "N" position. |
| not set properly. |
|
|
|
|
| The fuse has blown. | After checking for short circuits in the |
|
| wires, replace the fuse with one having |
|
| the same rating. |
• Installation using the
Nothing happens when | The computer chip in the unit is not | Press the reset button on the Control |
the buttons are pressed. | functioning normally. | unit . |
Accessory2
Accessory4 (Ø5 ⋅ 20 mm)
No sound can be heard, | The input/output wires or wiring | Reconnect the input/output wires and/or |
or the volume is low. | harness are connected incorrectly. | the wiring harness correctly. See the |
S
IRI
USS |
|
|
|
KTATE |
|
| |
C | LLIT |
| |
| ER | ADI | |
|
| 901 | OTU |
NER
Accessory3 (M4 ⋅ 8 mm)
Carpet
Board etc.
thickness: 20 mm or more
|
| section on "Connecting Wires to |
|
| Terminals". |
|
|
|
No broadcast can be | The Sirius antenna is not connected. | Connect it properly by referring to |
received. |
| "Connecting Wires to Terminals". |
|
|
|
| No subscription is established. | Subscribe to SIRIUS. |
|
|
|
• Installation using the velcro tapes
Accessory7
Carpet
The following messages are displayed when certain problems are occurring in your system. Take the recommended actions.
ANTENNA ERROR / ANT ERR :
Antenna is not connected correctly.
]Make sure the antenna is connected correctly and then turn OFF/ON of the SIRIUS source or Control unit.
TUNER ERROR / TUNE ERR :
Broadcast cannot be received due to an error in this unit.
]Turn OFF/ON of the SIRIUS source or Control unit, or press the reset button of Control unit.
ESN ERROR / ESN ERR :
ESN (Electronic Serial Number) is not registered in this unit.
]Consult your nearest service center.
10 | English- 11 |
