Installation location and cleaning
Select for installation a location where the stand can be
placed completely horizontal or where the front edge of
the support (petal-shaped part) can be attached
horizontally as shown in Figure A.
Do not install in locations where the entire support is at a
diagonal such as in Figure Bor where the monitor unit is
facing down such as in Figure C.
Thoroughly wipe away and dust or grease from the
installation location using a cloth which has been soaked
in a neutral cleaning agent and wrung out. Attach the
stand after allowing the installation location to dry.
1Install the shoe on the rear of the TV monitor
temporarily using the supplied hexagon wrench
(Accessary C).
When adjusting the fixing screw of the shoe, use the
hexagon wrench (Accessary C) that came with the
product. Using other hexagon wrenches may damage
the screw.
2Bend the stand support to conform to the shape of
the installation location.
3Adjust the shape of the support so that there is no
rattling or gap when the stand is placed on the
support.
4Peel off the protective strip from the double-sided
tape on the bottom of the stand and securely attach
the stand.
• Do not attach the double-sided tape more than once
or touch the adhesive with your fingers as this will
weaken its adhesive strength.
• If the temperature of the surface of the installation
location is low, warm it up using a heater or other
means before attaching the stand. Low temperature
may weaken the adhesive strength of the tape.
• The supplied stand is specially intended for this
product. Do not use it with another monitor.
5Secure the stand using the supplied tapping screw
(Accessory D).
6After attaching the stand, allow it to sit undisturbed for
24 hours. Take care not to apply any force to the stand
during this time.
7Insert the shoe of the monitor unit into the bracket
(Accessory B).
Insert the shoe into the
bracket (Accessory B) as far
as it goes.
8Adjust the height, horizontal and vertical angle of the
monitor unit, and securely tighten the installation
screws using the supplied hexagon wrench (Accessary
C).
You can also adjust the monitor unit's forward position
by loosening the angle adjustment knobs and
adjusting the angle of the monitor unit's installation
stand.
2CAUTION
2CAUTION
NOTE
2CAUTION
Installation for Monitor Unit
Installation8English
English
AB C
Accessory B
Accessory C
Shoe
Accessory D
Installation surface
Protective
strip
Tighten
Loosen
Accessory C