TK-2160
4
OPERATING FEATURES / REALIGNMENT
Programmable Auxiliary Functions
The AUX, Side 1, and Side 2 keys can be programmed
with the auxiliary functions listed below:
•2-Tone Encode
• Emergency ∗1
•Monitor Momentary
•Monitor Toggle
•None
•RF Power Low
•Scan
•Scan Temporary Delete
•Scrambler
•Squelch Off Momentary
•Squelch Off Toggle
∗1This function can be programmed only on the AUX key.

2. How to Enter Each Mode

Mode Operation
User mode Power ON
PC mode Received commands from PC

1. Modes

Mode Function
User mode For normal use.
PC mode Used for communication between the
radio and PC (IBM compatible).
Data programming Used to read and write frequency data
mode
and other features to and from the radio.
PC test mode Used to check the radio using the PC.
This feature is included in the KPG-
82D.
User mode
PC mode
PC test mode
Data programming
mode
PC tuning mode

REALIGNMENT

3.PC Mode

3-1. Preface
The TK-2160 transceiver is programmed using a personal
computer, a programming interface (KPG-22) and programming
software (KPG-82D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
3-2. Connection procedure
1. Connect the TK-2160 to the personal computer with the
interface cable.
2. When the POWER is switched on, user mode can be
entered immediately. When the PC sends a command,
the radio enters PC mode.
When data is transmitting from the transceiver, the red
LED lights.
When data is received by the transceiver, the green LED
lights.
Notes:
•The data stored in the personal computer must match the
model type when it is written into the EEPROM.
•Change the TK-2160 to PC mode, then attach the interface
cable.
3-3. KPG-22 description
(PC programming interface cable: Option)
The KPG-22 is required to interface the TK-2160 with the
computer. It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.
The KPG-22 connects the SP/MIC connector of the TK-2160
to the computer’s RS-232C serial port.
3-4. Programming software description
KPG-82D is the programming software for TK-2160
supplied on a CD-ROM. This software runs under Windows
98, ME, Windows 2000 or XP on an IBM-PC or compatible
machine.
The data can be input to or read from TK-2160 and edited
on the screen. The programmed or edited data can be printed
out. It is also possible to tune the transceiver.
Tuning cable
(E30-3216-05)
RF Power meter
or SSG
Gray +
Gray/Black –
1.5D-XV Lead wire +
1.5D-XV Shield wire –

}

}

SP
MIC
KPG-22
KPG-82D
IBM-PC
Fig. 1