Kenwood P-110 6Parts nomenclature and assembly, Connections, Installing the hinges, Removing the plastic tie, Caution:

6Parts nomenclature and assembly

P-110 (En)

Verify that all of the following parts are present before carrying out the assembly procedures.

First, set the MM. AMP switch on the bottom according to the type of your amplifier. (Refer to “Connections” below.)

Dust cover

AC plug adaptor (Only for some areas)

Rubber mat

Audio cords

AC cord

Center spindle

Turntable platter

SPEED

SPEED selector 33

45

Installing the hinges

Dust cover

Hinge

Removing the plastic tie

After connections, remove the plastic tie that retains the tonearm.

Motor puller cover

plastic tie

EP adaptor

Tonearm

Arm elevator

Cueing lever

Arm rest

Tonearm

Cartridge

Releasing the arm rest lock lever

CUT

CUT key

Connections

This until has a built-in RIAA equalizer amplifier, so it can be connected to an amplifier without PHONO (turntable) input jacks. According to the amplifier, set the MM.AMP switch on the bottom cover.

When the unit is connected	White	Rear panel of
		the amplifier
to the PHONO (MM) jacks : Audio cord
MM.AMP		L
OFF		R
ON	Red	PHONO

When the unit is connected	Rear panel of
	the amplifier
to the AUX jacks, etc. :
MM.AMP	L
OFF	R
ON
	AUX

MM.AMP

OFF

ON

Caution:

Do not apply oil or lubrication to the motor, tonearm, or any of the turntable’s mechanisms. Do not plug in the power cord until all connections are completed.