7
Using the stylus cover
Before operation, remove the stylus cover in the direction of the arrow
After record play, always put on the stylus cover to protect stylus tip.
Replacing the stylus
÷ Use an
÷ Remove this unit’s power cord from the AC outlet before replacing the stylus.
÷ One stylus is good for playing an LP record approximately 500 times.
Remove the existing | Install the new stylus as |
stylus as shown. | shown. |
Stylus |
|
Operating instructions
1Placing a record on the platter.
4Playing the record.
With an LP record |
| With an EP (single) record | |
LP |
| EP |
|
SPEED 45 | CUT | SPEED 45 | CUT |
33 |
| 33 |
|
EP adaptor
2Select 33 or 45.
When playing 33 |
rpm record. |
(1)Pick up and move the tonearm to the position where you wish to be- gin listening.
Tonearm
÷The turntable platter begins ro- tating when the tonearm is moved over the record.
(2)Tilt the cueing lever to the front.
÷The tonearm is lowered on the record surface and playback starts.
SPEED | 45 |
|
| When playing 45 | |
| 33 |
rpm record.
3Tilt the cueing lever to the rear.
÷The arm elevator rises.
÷It may happen that tonearm returns automatically to the arm rest before play start. If this occurs, repeat steps (1) and (2) again.
To pause record playback | To stop record playback |
Tilt the cueing lever to the rear.
CUT
| ÷ The tonearm automatically re- |
÷ To resume playback, set the | turns to the arm rest when |
cueing lever to front side. | playback is finished. |