Kenwood SK-70MB Box contents, Installation procedure

Box contents

Unpack your SK-70MB carefully and make sure that everything listed here is present. If anything is missing, notify your dealer immediately. If your SK-70MB was shipped to you directly, notify your shipper immediately.

2 x Bracket Halves

1 x Hardware Package

Installation procedure

Note: Before installing the SK-70MB, it will be necessary to remove the vehicle’s headliner. Refer to the LZH-70W Installation Manual for more complete installation information.

1.Fit the mounting bracket halves together so they span the distance between the vehicle roof crossmembers that are directly fore and aft of the console mounting location.

2.Use a marking pen to mark the top bracket half through 2 of the pilot holes on each angled side of the bottom bracket half. Use 4 of the supplied ½” self-tapping screws to connect the bracket halves together.

3.Using 4 screws on each end, attach the bracket to the crossmembers on the vehicle’s centerline

•Be sure not to drill through the vehicle’s roof (Measure the distance from the bracket’s surface to the roof; measure and mark the drill bit with masking tape to prevent the bit from touching the roof when drilling the holes)

•If the roof crossmembers are too narrow for you to use 4 screws on each end of the bracket, use 2 screws on each end

Step 2: Connecting the bracket halves together

Step 3: Attaching the bracket to the crossmembers

www.kenwoodusa.com	Main Office
	P.O. Box 22745
www.kenwoodusa.com/inquiry	Long Beach, CA 90801-5745
1-800-KENWOOD	Canada Office
	6070 Kestrel Road
	Mississaugua, Ontario L5T 1S8