SCAN

Scan is useful for monitoring signals on the transceiver channels. When scanning, the transceiver checks for a signal on each channel and only stops if a signal is present.

The transceiver will remain on a busy channel until the signal is no longer present. Your dealer programs the delay time between signal drop-out and Scan resumption. If a signal is received during the delay time, the transceiver will remain on the same channel.

Note: You can only use Scan if your dealer has programmed at least 2 channels and they are not locked out of Scan.

To start scanning, momentarily press the key programmed as either Scan or Scan + Temporary Delete.

•Scanning starts from the current channel and ascends through the channel numbers.

•The LED indicator flashes green.

•When a signal is received on a channel and signalling matches, the LED indicator lights green.

To end Scan, press the Scan or Scan + Temporary Delete key again.

■Priority Scan

If enabled, a priority channel is set up one of two ways:

•Your dealer may set up a fixed priority channel on your transceiver.

•You can select your own priority channel, prior to scanning, using the Channel selector.

During Scan, if a priority channel has been set up on your transceiver, the transceiver will automatically change to the priority channel when a call is received on it, even if a call is being received on a regular channel.

The transceiver will remain on the Priority channel until the signal drops out. Your dealer programs the delay time between signal drop-out and scan resumption.

17