Kenwood TS-480HX, TS-480SAT PORTABLE BRACKET (E-TYPE ONLY), FUSES

5
1 INSTALLATION
PORTABLE BRACKET (E-TYPE ONLY)
Using the supplied Portable Bracket, you can carry the Remote Control panel and TX/ RX unit together.
Two TX/ RX unit positions are available. If you do not use the EXT.SP, REMOTE and DATA connectors, place the
TX/ RX unit in front position. If you use the EXT.SP, REMOTE or DATA connector, place the TX/ RX unit to the
back position. You can also attach the handle as shown if necessary. Use the supplied short cable (RJ11/ 20 cm)
to connect the Remote Control panel and the TX/ RX unit.
FUSES
The following fuses are used in the TS-480HX/ SAT transceiver. If a fuse blows, determine the cause then correct
the problem. Only after the problem has been resolved, replace the blown fuse with a new one with the specified
ratings. If newly installed fuses continue to blow, disconnect the power plug and contact a KENWOOD service
center or your dealer for assistance.
noitacoLesuF gnitaRtnerruCesuF
TAS/XH084-ST
)tinuXR/XT(
A4
)renutannetnalanretxenaroF(
rewopCDdeilppuS
elbac A52
SEMS screw
(M4 x 10 mm)
SEMS screw
(M4 x 10 mm)
DC
13.8V
1
DC 2 13.8V
AT
GNDGNDGND
221
Binding head screw
(M4 x 8 mm)
Flat-head screw
(M4 x 12 mm)
RJ11/ 20 cm
Carrying handle
PANEL
MIC
PADDLE
KEY
EXT.SP DATA REMOTE
COM
PANEL
MIC
PADDLE
KEY
EXT.SP DATA REMOTE
COM
1 Remove 7 screws at the bottom of the TX/ RX unit.
2 Remove 8 screws inside of the TX/ RX unit.
3Lift the shield cover.
4Replace 4 A fuse.