Kenwood DM-SE7, DP-SE7, R-SE7, X-SE7 Before applying power, Safety precautions, WARNING :, For the United Kingdom, (Except for some areas), The marking of products using lasers, CLASS, CAUTION

2	Before applying power	Caution : Read this page carefully	to ensure safe operation.
2			Before applying power

R-SE7/DP-SE7/X-SE7 (En)

Units are designed for operation as follows.

Europe and U.K. .................................................	AC 230 V only
U.S.A. and Canada ............................................	AC 120 V only

Preparation section

Basic section

For the United KingdomFactory fitted moulded mains plug

1.The mains plug contains a fuse. For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse.

2.The fuse cover must be refitted when replacing the fuse in the moulded plug.

3.Do not cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or adapter, or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply.

IMPORTANT : The wires in the mains lead are coloured in accordance with the following code:

Blue : Neutral

Brown : Live

Do not connect those leads to the earth terminal of a three-pin plug.

The marking of products using lasers(Except for some areas)CLASS 1LASER PRODUCT

The marking is located on the rear panel and says that the component uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit.

Application section

Knowledge sections

Safety precautions		WARNING : TO PREVENT FIRE OR ELECTRIC
		SHOCK, DO NOT EXPOSE THIS AP-
		PLIANCE TO RAIN OR MOISTURE.

		CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
	CAUTION
		COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVIC-
	RISK OF ELECTRIC SHOCK
	DO NOT OPEN	ING TO QUALIFIED SERVICE PERSONNEL.
		ING TO QUALIFIED SERVICE PERSONNEL.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.