2533 ADIRONDACK BAR STOOL
Contents: | (1) | Short Cross Brace | |
(1) | Seat, (1) Back | (4) | Cross Braces |
(2) Arm Rests | (22) 1/4 - 20 x 2” Bolts | ||
(2) | Front Chair legs | (6) | 1/4 - 20 x 2 1/2” Bolts |
(2) | Back Chair legs | (12) Washers | |
(1) | Footrest | (12) Locknuts | |
(2) | Side Braces | Locknut | Washer |
Tools Required:
7/16” Wrench
#3 Phillips Head Screwdriver
1.
Assembly Instructions
a. Align predrilled then insert bolts to attach front legs.
Place arm rest on top of chair legs, align front predrilled holes, insert bolt.
b. Align predrilled holes then insert bolts to attach back legs.
1. | a. With the wing on the post facing front, |
| |
align the predrilled holes on front leg to the seat | |
and insert the 1/4 - 20 x 2” Bolts through the leg | |
in thru the seat. Clean any plastic residue from the | |
bolt then slide a washer on. Screw on the locknut | |
and then tighten it with the wrench and phillips | |
screwdriver. Repeat on the other front leg. | |
b. Align the predrilled holes on the back leg to | |
the seat and insert the 1/4 - 20 x 2” Bolts through | |
the leg in thru the seat. Clean any plastic residue |
2.
3. | Properly Seated |
Washer and Nut. | |
| Attach the back of the |
3b. | chair by aligning holes |
on the arm and the seat | |
| to insert bolt. |
3a. |
|
4.
from the bolt then slide a washer on. Screw on the | |
locknut and then tighten it with the wrench and | |
phillips screwdriver. Repeat on the other back leg. | |
2. | Place arm rest on top of chair legs align the |
| |
front predrilled holes and insert the 1/4 - 20 x 2” | |
Bolts through the leg and in thru the arm. Clean | |
off any plastic residue then slide a washer on the | |
end of bolt. Screw on the locknut and then tighten | |
it with the wrench and phillips screwdriver. | |
3. | a. Attach the back of the chair to the seat |
| |
by aligning holes and inserting a 1/4 - 20 x 2” | |
Bolt then tighten with a phillips screwdriver. | |
b. Attach the back of the chair to the arm by | |
aligning holes and inserting a 1/4 - 20 x 2 1/2” | |
Bolt thru the arm, leg and into the chair back, then | |
tighten with a phillips screwdriver. |
Repeat on both sides.
4.Attach the cross braces of the chair to the legs by aligning holes and inserting a 1/4 - 20 x 2” Bolt through the leg into the cross brace and tighten with a phillips screwdriver.
Repeat on other leg.
Do Front and Back cross braces.
Copyright © Kettler USA 309.01
Attach the braces to the legs by aligning holes and inserting a 2” bolt.
Slide washer then |
locknut onto end of |
bolt then tighten. |