Keurig B100 STEP Assemble Drip Tray and K-CupHolder, STEP Turn Brewer ON and Fill with Water

GETTING STARTED

Please check the contents of the box. It should contain:

1 Keurig B100 Brewer

1 Drip Tray and Cleaning Tool (under Drip Tray)

1 Drip Tray Plate

STEP 1

Assemble Drip Tray and K-Cup Holder

1.Ensure that Drip Tray Plate rests on Drip Tray and place Drip Tray Assembly at the front base of the Brewer.

2.Open the Brew Drawer and insert the K-Cup Holder into the Brew Drawer, and push down until it snaps firmly into place. (figure 1)

K-Cup Holder Assembly

1 K-Cup Holder Assembly (K-Cup Holder and Funnel)

Water Fill & Lid

Red

“Not Ready”

Light

“Brew” Button

Green “Ready” Light

Drain Cap (in rear)

STEP 2

Turn Brewer ON and Fill with Water

1.Plug Brewer in.

2.Turn power switch found on rear of Brewer to “ON”.

3.Fill the Brewer with up to 80 oz of water on the initial fill (regular re-fill quantity is 64 oz) by pouring water

into the Water Fill Area.

4. The Water Fill Indicator will be flashing with a blue light while you are filling or re-filling, and will stop flashing when water passes the minimum fill level.

5. The Red “Not Ready” Light indicates the Brewer is not ready (the water is heating). Wait for 8-10 minutes. The Green “Ready” Light will illuminate when the water is heated.

figure 1

Water Fill Lid

Water Fill Area

Red “Not Ready” Light

Green “Ready” Light

Water Fill Indicator

figure 2

Brew

Drawer

On/Off Switch (in rear)

6.The Brewer will indicate that it has reached the full water level with four audible beeps and the Green “Ready” Light will flash four times.

STEP 3

Perform a Cleansing Brew then Brew Your First Cup

Perform a Cleansing Brew

1.Place a mug on the Drip Tray.

2.Open and close Brew Drawer.

3.Press Brew Button; hot water will dispense into mug. Dispose of water in sink.

Brew and Enjoy a Fresh Brewed Mug of Coffee or Tea

1 Place a mug on the Drip Tray.

2. Open Brew Drawer and place a K-Cup into the Holder.

(figure 3)

3. Close Brew Drawer (Flashing Green “Ready” Light

We recommend keeping your brewer turned “ON” at all times, so it is always ready to brew a fresh cup. This will use minimal electrical power (the equivalent of a 60W light bulb). We recommend turning power “OFF” if you will not be using it for several days.

Do not remove foil or puncture K-Cup.

Brew Button

	Cleaning Tool (under Drip Tray)
Drip
Tray Plate	Water Fill Indicator
	Drip Tray

indicates ready to brew).

4. Press Brew Button and fresh coffee or tea will

dispense into your mug in about 45 seconds.

5. Once brewing is done, remove K-Cup and dispose.

6. The Brewer is ready to brew your next mug.

K-Cup

Brew Drawer

figure 3