Disc handling precautions
•To keep the disc clean, handle the disc by its edge. Do not touch
the surface.
•Do not stick paper or tape on the disc.
If there is glue (or a similar substance) on the disc, remove the glue
completely before using the disc.
•Do not expose the disc to direct sunlight or heat sources such as
hot air ducts, or leave it in a car parked in direct sunlight as a
considerable rise in temperature will adversely affect the disc.
•After playing, store the disc in its case.
•Do not write on the label side with a ball-point pen or other writing
implements.
•Be careful not to drop, bend, or crack the disc.
Disc cleaning precautions
•Before playing, clean the disc with a cleaning cloth. Wipe the disc
from the center outward.
•Do not use solvents such as benzine, thinner, commercially avail-
able cleaners or antistatic spray intended for vinyl LPs.
Disc playing precautions
•Do not place more than one disc in the disc tray at a time.
•Do not place the disc wrong side up in the tray.
•Do not try to close the disc tray when the disc is not placed
properly in the tray.
Accessories
Check that you have the following items:
• Remote Control x1
• Owner’s Manual x1
Warranty Card x1
Installing batteries in the remote control
1. Open the battery cover on the back of the remote.
2. Insert two AAA batteries, making sure that the polarities (+ and -)
are aligned correctly.
3. Replace the battery cover.
You can control the system using the supplied remote. When using
the remote, point it at the remote sensor on the front panel of this
system.
6
General Information(continued)Note:
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new battery with an old one, always replace the
batteries at the same time using fresh, new batteries.
• Do not drop any foreign objects into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or lighting
apparatuses, doing so may cause the remote to malfunction.
• If you do not use the remote for an extended period of time,
remove the batteries to avoid any possible damage from battery
leakage and erosion.
Notes on disc
•
If remote doesn’t operate properly:
Check the polarity (+,-) of the batteries (Dry-Cell).
Check if the batteries are drained.
Check if remote sensor is blocked by obstacles.
Check if there is any fluorescent lighting nearby.
•
•
•
•