Installing the Coin Mechanism:
The step by step procedure for installing the coin changer is as follows:
1.Unlock the coin changer cabinet fascia [Figure 11] and remove it by lifting up at coin retrieval opening [Figure 12]. Remove the top panel of the coin changer cabinet by unscrewing the two screws at the rear of the unit [Figure 13] and sliding the panel rearward and lifting up.
Coin retrieval opening
Figure 11 | Figure 12 |
|
2. Mount and connect the coin mechanism.
Figure 13
Figure 14
Locate the mounting screws of the cabinet shown in fig 14.
Figure 15
Slide coin mechanism back into the cabinet insuring the cabinet mounting screws locate into the holes at the back of the unit shown in fig 15. Note, some changers may require a slight deflection of the cabinet side panels during insertion.
Figure 16
Once the coin mechanism is seated properly connect the unit to the connector as shown and route cord as shown in fig 16.
Figure 17
Replace the top panel. When mounted properly the coin mechanism should have a flush look and feel as shown in fig 17.
B3000 SERVICE MANUAL |
|
77 |