Keurig SS-300C manual Buttons and Indicators, Setting Up Your Brewer, Charcoal Water Filter

Buttons and Indicators

Power Button (does not illuminate) Press to turn the Brewer on and off.

Add Water Indicator LED

Indicator will illuminate blue – Fill the water reservoir with cold water until it reaches just under the rim of the desired level­– 6, 8, or 10 ounces (180, 235 or 300 mL) on the Water Level Guide.

Brew and Hot Water Buttons When buttons are flashing blue it indicates that a selection (Brew or Hot Water) needs to be made. Once a selection is made button is solid blue, indicating water is heating and dispensing of beverage will begin in approximately 2 minutes.

Your Next Brew When the brewing process is complete, the Add Water indicator LED will illuminate. At this point you can begin making the next beverage, or you can power off.

Automatic Shut-OffAs a safety feature, your brewer will automatically shut off at any stage when it is idle for longer than 90 seconds. Press the power button to restart. If it shuts off while the Brew button LED was flashing blue, lift and lower brewer handle to

Setting Up Your Brewer

Initial Cleaning and First Brew

Perform an initial cleaning before making your first beverage. Follow these instructions but do not insert

aK-Cup®.

1.Plug the power cord into an independent, grounded outlet. Press the Power button to turn the unit on.

2.Press the Hot Water button. The Add Water indicator will illuminate.

3.Lift the reservoir lid.

4.Pour water into the water reservoir until it reaches the 10 oz. rim on the water level guide. Close the lid.

6.Wait until all the water has drained into the brewer before lowering the brewer handle completely.

7.Place mug on the drip tray.

8.The Hot Water button LED will remain on, indicating that the water is heating. After about 2 minutes, the water starts to dispense.

9.The one-time cleaning process is complete. Discard hot water. Your brewer is ready to use.

Charcoal Water Filter

Your coffeemaker comes with a charcoal water filter that eliminates chlorine, bad tastes and odors from tap water.

K-cup®Indicator LED

Indicator will illuminate blue – The blue light flashes to indicate that the brewing head needs to be opened and a K-Cup®or My K-Cup®needs to be inserted. The light will continue stay on until you lift the brewer handle.

reset.

Drip Tray Overfill Indicator

Will pop up when excess coffee that does not dispense into mug or residual condensation from the brewing process fill the drip tray.

Inserting the Water Filter

1. Remove the filter and filter holder from the polybag.

2. Soak the filter, fully immersed in cold tap water, for 15 minutes.

3. Rotate the water filter compartment cover counterclockwise to remove the charcoal water filter holder.

5.Lift the brewer handle but do not add a K-cup®. Water starts to drain from the water reservoir into the brewer.

8 9