Assembly of CardioMax Exercise Bike
Put out all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning.
1. Loosen the adjustment knob (41) on the front frame (1). Slide the rear frame backward and secure with the adjustment knob (41). Attach the rear stabilizer (3) onto the rear frame with car- riage bolts (49, acorn nuts (37), and washers.
2.Attach the seat frame (4) onto the rear frame with carriage bolts (48), Nylock nuts (52), and washers (24).
3.Attach the seat frame (4) onto the rear frame with carriage bolts (48), Nylock nuts (52), and washers (24).
4.Thread the right pedal (38) onto the right side of the crank (8) as shown. Tighten the pedal securely. Select the right pedal strap which has R marked on the bottom side of the strap. Snap the three hole end onto the inside edge of the right pedal (38). Snap the other three hole end onto outside edge of the right pedal (38) Select adjustment holes which allow your foot to be easily removed from the pedals. Do the same way to attach the left pedal (36) onto the left side of the crank (8) and snap the left pedal strap onto the left pedal (36).
5.Install two “AA” batteries into the electronic meter (33). Plug in the sensor wire (31) to the electonic meter (33). Place the electronic meter (33) onto the plate on the front frame (1) and secure with screws (57).
1
41
1
5237
37 52
3
48
4 2
24 | 24 | |
|
| 52 |
52 | 24 | 41 |
| 52 | 1 |
|
| |
6 | 7 |
