Assembly
3.Locate the right upright. Connect the console harness together. One side of har- ness is located near the motor cover on the bottom right side. The other end is
located inside the right upright.
Note: Make sure that the console har- ness is inside of the upright and not being pinched.
Slide the right upright onto the base frame. Secure the right upright to the base frame by using four bolts M10x25
and four washers 10.
Bolt M10x25
Washer 10
Console
Harness
4.Locate the cross bar. Slide the cross bar in between the left and right uprights. Secure the cross bar using one washer M8 and one bolt M8x57 on each side.
Figure 3: Right Upright Installation
Washer M8 |
Cross Bar |
Bolt M8x57 |
