Assembly
FIGURE 3
Step 1:
Secure left pedal (5a) to left pedal tube (4a) with screws (47), nylock nuts (49) and washers (48). Then secure left pedal tube (4a) to unit by lin- ing up the pedal tube to the axle with screws (50), nylock nuts (49) and washer (48). Repeat on right side.
Figure 3
50 47
5a
48
49
4a
48
49
FIGURE 4
Step 1:
Connect the extension wires
(72) to the sensor Wires (73); |
Connect the tension cable (68) |
Figure 4
4A 4B
to the tension controller (66) as |
following steps |
68
68
Step 2:
Put the cable end (66) into the spring hook (68) (figure 4A).
Step 3:
Pull the knob and insert the short cable (66) into the gap of the bracket (68) (pic 4B). Tension is increased by turning the knob clockwise.
Step 4:
Secure the upright post (3) onto Main Frame (1) with Washers (34) and Screws (65).
66 66
3
72 | 66 | 68 |
34 | 73 |
|
65
