Features
Injection Molded Polymineral Cone with ISD™ (Inverted Structural Dome) is a high performance composite, which remains rigid, minimizes cone flex and lowers harmonic distortion. The ES subwoofer cone moves as a light weight piston, exhibiting power and control.
Double Stitched Surround adds a mechanical fastener to the chemical adhesives. This duo prevents the cone and surround from separating in the harshest conditions.
Optimized Polyfoam Ribbed Surround Radius allows extended cone excursion for additional bass output and higher SPL, and couples the suspension into a conjoined
Model: | VES12 |
|
|
|
|
Nominal Impedance [Zn], ohm | 4 |
Power Handling Watts, Peak (RMS) | 375 (125) |
Enclosure Top Surface Depth, in (cm) | 8.5 (21.7) |
Enclosure Bottom Surface Depth, in (cm) | 14.8 (37.5) |
Enclosure Height, in (cm) | 14.7 (37.2) |
Enclosure Width, in (cm) | 18.7 (47.6) |
Human |
| ||||||
| |||||||
Kicker’s award winning ES subwoofers to offer bass performance that | Features | ||||||
surpasses most custom made boxes. |
| ||||||
|
| ||||||
|
| ||||||
Backplate |
|
| |||||
1. Optimizes heat transfer efficiency for cooler operation |
| ||||||
and maximum power handling ability. |
|
| |||||
2. Eliminates erratic magnetic flux from the |
| ||||||
3. Releases pressure under the suspension for uniform |
| ||||||
cone movement and responsive low bass. |
|
| |||||
4. Prevents the |
|
| |||||
corresponding damage. |
|
| |||||
New Enhanced BAM (Basket and Motor) Assembly utilizes a high |
| ||||||
strength steel basket, features a |
| ||||||
a solid foundation for the |
| ||||||
Perimeter Venting in the BAM relieves pressure from under the |
| ||||||
spider, supports a linear excursion, and helps dissipate heat from the |
| ||||||
voice coil and motor structure. |
|
| |||||
|
|
|
| At least 4” (10cm) | Rear mounting, |
| |
|
|
|
| from the vent | speaker faces |
| |
|
|
|
|
|
|
| |
|
|
|
|
|
| front of vehicle |
|
|
|
|
|
|
|
|
|
|
|
|
| VES12 |
|
| |
Front of | Mount Brackets with |
| |||||
Vehicle |
| ||||||
|
|
|
|
|
| supplied screws on |
|
|
|
|
|
|
| each side of the |
|
|
|
|
| At least 4” (10cm) | VES12 enclosure |
| |
|
|
|
|
|
| ||
|
|
|
|
|
| ||
|
|
|
| ||||
|
|
|
| from the vent |
|
| |
|
| Front mounting, speaker faces rear of vehicle |
|
|
ES Subwoofer Enclosures | 08302005+05VES12 3 |