Kicker ZX300.2, ZX300.4, ZX300.3 manual Mono Operation, Minimum impedance of 2 ohms, Woofer ZX300.1

MONO OPERATION

minimum impedance of 2 ohms

	AUTO	INPUT LR	L	R GAIN BASS
	TURN ON	SENSITIVITY		BOOST	XOVER
	+12V DC AUDIO	LO		OFF	OFF LO
	OFFSET	HI		ON
		REMOTE BASS
	SPKR +	SPKR -
+		–
		signal in	signal out

woofer

ZX300.1

OPERATION

AUTO	INPUT	L	R	L	R	GAIN	BASS
TURN ON	SENSITIVITY						BOOST	XOVER
+12V DC AUDIO	LO	INPUT		OUTPUT			OFF	OFF LO
OFFSET
	HI						ON
			REMOTE BASS
SPKR +	SPKR -

Automatic Turn-On Selection: The ZX series offers three different automatic turn-on modes that can be selected on the end panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode causes the REM terminal to have +12V out for turning on additional amplifi ers.

•Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit. Run 18 gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM between the amplifi er’s positive and negative power terminals. This is the preferred automatic turn-on method.

•DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC Offset mode detects a 6V DC offset from the HI-Level speaker outputs when the source unit has been turned on.

•Signal Sense Turn-On: The Audio setting is the fi nal alternative for Automatic turn-on. This is a Signal Sense turn-on method that detects the incoming audio signal from your source unit and automatically turns on the amp. This turn-on method will not work properly if the input gain control is not set appropriately.

4 ZX AMPLIFIERS

2010 ZX 300.1 400.1 500.1 750.1 RevC.indd 4

10/15/2009 10:55:55 AM