5-6-7 FT. REAR DISCHARGE FINISHING

MOWER

TO REPLACE BELT:

STEP 1

Remove top cover.

STEP 2

Release adjustment spring.

STEP 3

Loosen nut on adjustment pulley to allow for movement. (See Fig-

 

ure “D”)

STEP 4

Loosen nut on right side of “L” bracket. (See Figure “D”)

STEP 5

Loosen belt by moving adjustment pulley in opposite direction you

 

would to tighten belt.

STEP 6

Remove nuts (2) from hinged gearbox plate from finishing mower

 

deck. (See Figure E)

STEP 7

Loosen nuts (2) from hinged bolt gearbox plate.

STEP 8

Raise gearbox assembly and slip out belt.

STEP 9

See Figure D for belt placement on pulleys.

STEP 10

Do step 5 thru 7 under Section: "TO ADJUST BELT" to tighten.

TO ADJUST BELT:

STEP 1

Remove top cover.

STEP 2

Release adjustment spring.

STEP 3

Loosen nut on adjustment pulley to allow for movement. (See Fig-

 

ure D )

STEP 4

Loosen nut on right side of “L” bracket. (See Figure D)

STEP 5

Turn nut on left side of “L” bracket in counter clockwise direction

 

until belt is tight.

STEP 6

Re-tighten nut on right side of “L” bracket and nut on adjustment

 

pulley.

STEP 7

Re-hook adjustment spring. (See Figure “D”)

22

 

Page 22
Image 22
King Kutter Free Floating manual To Replace Belt Step, To Adjust Belt