![](/images/new-backgrounds/1061913/6191319x1.webp)
Adjustthe Door
Depending on your model, your refrigerator may have two
(Style 1) or four (Style 2) adjustable rollers located at the base of the refrigerator. If your refrigerator seems unsteady or you want the door to close easier, adjust the refrigerator's tilt using the instructions below.
1.Remove the base grille. Grasp the grille firmly and pull it toward you.
2.Using a screwdriver or ³⁄₈" hex driver, turn the roller adjustment screw(s) on each side to raise or lower that side of the refrigerator.
NOTE: Having someone push against the top of the refrigerator takes some weight off the adjustment screws and rollers. This makes it easier to turn the screws.
■To raise, turn the roller adjustment screw to the right.
■To lower, turn the roller adjustment screw to the left.
NOTE: It may take several turns of the roller adjustment screw to adjust the tilt of the refrigerator.
Style 1 - Front leveling
A
B
A. Roller adjustment screw
B. Stabilizing foot
Style 2 - Front and rear leveling
A BB A
CC
A. Front adjustment screw
B. Rear adjustment screw
C. Stabilizing foot
3.Open the door again to make sure that it closes as easily as you like. If not, tilt the refrigerator slightly more to the rear by turning both front adjustment screws to the right. It may take several more turns, and you should turn both adjustment screws the same amount.
4.Lower the stabilizing foot by turning it clockwise until it is firmly against floor.
5.Turn the front adjustment screws counterclockwise to allow the full weight of the refrigerator to rest on the stabilizing feet.
6.Replace the base grille.
Water System Preparation
Please read before using the water system.
Immediately after installation, follow the steps below to make sure that the water system is properly flushed.
1.Turn off the ice maker by opening the freezer door and lifting up the wire shutoff arm as shown.
2.Install the interior water filter. The interior water filter mounting bracket is located on the left side wall of the refrigerator compartment.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
■Remove blue bypass cap and retain for later use.
■Remove the interior water filter from its packaging. Remove the sealing label from the end of the filter and insert it into the filter head.
■Gently rotate the filter clockwise until it stops. Then snap the filter cover closed.
3.Flush the water system by dispensing and discarding 2 to 3 gal. (8 to 12 L) of water. Flushing the system will take approximately 6 to 7 minutes and will help clear air from the line. Additional flushing may be required in some households.
NOTE: As air is cleared from the system, water may spurt out of the dispenser.
4.Inspect the filter system for water leaks. If you see water leaks, see the “Troubleshooting” section.
5.Turn on the ice maker by opening the freezer door and lowering the wire shutoff arm as shown. Please refer to the “Ice Maker” section for further instructions on the operation of your ice maker.
■Allow 24 hours to produce the first batch of ice.
■Discard the first three batches of ice produced.
10