NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control to the Off position as shown and then disconnect the refrigerator from the electrical source.
When you are finished, reconnect the refrigerator to the electrical source and reset the control to the desired setting. See “Using the Control.”
INSTALLATION
INSTRUCTIONS
Unpacking
WARNING
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
Removing packaging materials
■Using a
■Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
■Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see the “Refrigerator Safety” section.
■Dispose of all packaging materials properly.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it.
Do not wiggle or “walk” the refrigerator when trying to move it, as floor damage could occur.
Clean Before Using
After you remove all of the packaging materials, clean the inside of your refrigerator before using it. See the cleaning instructions in the “Refrigerator Care” section.
Install the Leveling Legs(optional)
IMPORTANT:
■Always lay the refrigerator with the hinge facing upward during the leveling leg installation. If you lay the refrigerator on its back, you can damage the refrigerator.
■Do not place refrigerator on its top. It may damage the compressor.
■Allow the refrigerator to sit upright for 4 hours before plugging into an electrical outlet.
1.Using two or more people, lay the refrigerator on its side.
2.Screw two leveling legs into the bottom of the refrigerator at the front.
3.Screw two leveling legs into the bottom of the refrigerator at the rear.
4.Using two or more people, stand the refrigerator upright.
5.Allow the refrigerator to sit upright for 4 hours.
IMPORTANT: To prevent floor damage, keep the cardboard shipping piece or plywood under the refrigerator until it is installed in the operating position.
6.Move the refrigerator to its final location. Be sure to move the refrigerator straight back and evenly into the opening.
7.Lower the front legs just enough to lift the cabinet up off of the floor.
8.Adjust the legs to level the refrigerator:
■Turn the leveling leg to the right (clockwise) to lower that side of the refrigerator.
■Turn the leveling leg to the left (counterclockwise) to raise that side of the refrigerator.
5
