Now start...

with dishwasher in kitchen.

Disconnect electric supply before installing dishwasher.

\

Cut 1” holes for water,drain’ and electrical lines within shaded area.

Thd unshaded

area must

 

be

free of

pipes,

‘“\I

drain

hose

or wires.

Rough in water and drain

Numbers

 

IIm lines to the dishwasher

correspond

13.

cabinet opening using one of the

to steps.

 

routing methods shown. Cut 1” hole

 

in cabinet, rear wall or floor for water and drain lines.

8. lv

18.A&?-l

12Install a shutoff valve in the

1n I water line where it can be easily used.

13Flush water line to get rid of W any particles that may clog inlet valve. Tbrn shutoff valve-to the

“OFF”position.

14Check that there are no n sharp bends or kinks in

water line that might restrict water flow.

Install air gap. Attach drain hose to air gap or waste

tee. See “Drainrequirements”,

Electrical Shock Hazard l Disconnect electrical power

at the service panel (fuse box or circuit box).

lMake sure that the water supply line, drain line and wiring do not touch any exposed terminals of the dishwasher wiring.

Failure to do so could result in serious Injury or death.

Cut a 1 inch hole in the cabinet for the electrical

wiring to pass through. If this hole is cut in a wood cabinet, the hole should be sanded until smooth. If the hole is cut in a metal cabinet, the hole must be covered by a grommet (Pan No. 302797). Run flexible cable from fused disconnect, circuit breaker or junction box through hole in cabinet. Cable should extend 24” from back wall.

-,

Remove the 2 screws lu- n below the access panel. Press up on tabs and pull out bottom of access panel to unhook tabs from frame. Then pull the access panel downward to slide the panel flanges out from behind the support channel. Set the access panel aside on a protective covering. Remove the 2 toe-panel screws. Remove the toe

panel.

I I

 

The dishwasher is shipped /8 n to be installed in 34” cabinet opening. Measure height of cabinet opening from underside of countertop to floor. Adjust leveling legs to required opening height.

Page 5

Page 5
Image 5
KitchenAid 4171206 installation instructions Now start