KitchenAid 4176199 installation instructions Now start, Use and Care Information

Now start...

With pump in room where it will be installed.

Determine where you wish to locate water pump and water bottle. The

water bottle and water pump should be installed on the same level.

The water bottle and water pump must be located close together since the tubing connecting the pump to the water bottle is 6 feet

long. Use existing tubing between water pump and water bottle. Do Not cut this tubing or add tubing between pump and water bottle. Do Not remove clamp on end of tubing that connects inner tubing to outer tubing.

Suggested locations:

l Under the sink - especially for faucet connection.

l Cabinet next to outlet connection.

21Determine where you will need to run

. water lines and the length of tubing that will be needed. If more tubing is needed

than what is supplied, tubing (Part No.4319151) and tubing connectors (Part No. 4319153) can be obtained from your KitchenAid dealer or authorized parts distributor.

1

C1	Attach bottle cap to water bottle.
	Push the tubing into the water bottle

until the end of the tubing reaches the bottom of the bottle. Do Not remove clamp from end of

tubing.

141Insert one end of the l/4” O.D. outlet

. tubing l/2” to 3/4” into connector located on outside of pump. Check that you have pushed tubing into connector as far as it will go.

Route the tubing to the faucet or refrigerator.

Cut tubing to length needed. Use proper fitting to attach tubing to faucet or refrigerator. A “T” fitting, (Part No. 4319152), for routing tubing to more than one location is available from your KitchenAid dealer or authorized parts distributor.

El. Plug power supply cord into grounded, electrical outlet. Press the switch to the

“I”position.

ctor

tub

collet

u-HlRun enough water through faucet or refrigerator to fill a glass or other

container. Check all connections for leaks. If a connection leaks, push in collet and remove tubing. Cut off l/2” of tubing and reinsert into connector.

If unit is connected ONLY to a refrigerator icemaker, the icemaker will have to call for water before pump can be checked for leaks.

Keep Installation Instructions

for future reference. The instructions will make it simple to reinstall your water pump.

Use and Care

Information

The water pump operates automatically when outlet (faucet, etc.) is opened. When the outlet is closed, the water pump automatically stops operating.

When water bottle empties during

Use: Pressurized air is expelled through faucet or refrigerator when water bottle is empty.

Turn the faucet to “OFF”position or stop dispensing from the refrigerator.

121Press the switch on the water ’ pump to the “0” position.

/31. Remove bottle cap from water bottle. Replace empty water bottle. Attach

bottle cap to full water bottle.

14. Press the switch on the water pump to the “I”position.

If water bottle empties while

unattended, the pump will run for 2-i/2 minutes and then automatically shut off.

I I

Press the switch on the water pump to the “0” position.

121. Remove bottle cap from water bottle. Replace empty water bottle. Attach

bottle cap to full water bottle.

/31. Press the switch on the water pump to the “I”position.

If water system is ex osed to temperatures below tl 2-F, the system

must be drained.

Remove tube from bottle. Open all outlets and run pump to inject air through all outlets.

Cleaning and sanitizing system:

System should be cleaned after extended periods of non-use.

El Add one-half teaspoon of chlorine ’ bleach to one gallon of water.

Insert tube into solution and start pump.

131. Open all outlets to fill system with solution. Let stand five minutes.

M. -Flushlsystem with water until

chlorine is removed.

Panel B