Installation
Site Selection and
Preparation
!NOTE 1: A 15 Amp, 120 Volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
WARNING: Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.
①Select a suitable location that is not susceptible to moisture and is away from drapes, furniture and high traffic.
②For ease of electrical hook up you may wish to locate the
fireplace near an existing outlet (refer to NOTE 1) for
If installing a new outlet for this electric fireplace:
•Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons.
•Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician.
The dimensions of the firebox are 26 inches (660.5 mm) wide X
18 ⅞ inches (479.5 mm) high X 8 ¾ inches (223 mm) deep. The firebox does not require any additional venting.
For all installation options, ensure that the fireplace opening has the following MINIMUM dimensions (Figure 1):
7
