Before you start...
Your safety and the safety of others is very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol.This symbol alerts you to hazards that can kill
or hurt you and others. All safety messages will be preceded by the safety alert symbol and the word “DANGER” or “WARNING”. These words mean:
DANGER
You will be killed or seriously injured if you don’t follow instructions.
WARNING
You can be killed or seriously injured if you don’t follow instructions.
All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
Important: Observe all governing codes and ordinances.
Proper installation is your responsibility. Have a qualified technician install this oven.
Oven location should be away from strong draft areas, such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance.
Recessed installation area must provide complete enclosure around the recessed portion of the oven.
Electrical ground is required. See “Electrical requirements.”
Electrical supply outlet should be located in the rear wall on the lower right side of the cutout or in an adjacent cabinet. The outlet must be recessed. If the electrical outlet is located in an adjacent cabinet, provide a
Oven support surface MUST be solid, level and flush with bottom of cabinet cutout.
There is no provision to level the oven after it has been installed. If the installation is not level, the door may slide open or not seal tightly allowing heat to escape resulting in poor oven performance.
It is the customer’s responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70
—latest edition*, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
*National Fire Protection Association One Batterymarch Park
Quincy, Massachusetts 02269
Tools needed for installation: | Parts supplied: |
Phillips screwdriver
2 screws
2