Installation
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to follow this instruction can result in back or other injury.
Important: Use both hands to remove oven drawer.
Do Not use handle or drawer slides for lifting.
1.Turn power supply off. Move oven close to final position.
•Remove and discard shipping materials, tape and protective film from the oven.
•Remove and set aside racks and other parts from inside oven.
2.Remove the drawer:
• Pull drawer to its full open position.
•Press tab down on right and lift tab upward on left, then slide drawer out about 1 inch.
•Carefully remove the drawer from the slides holding on to the sides, not the drawer front.
•Set drawer aside on protected surface.
3.Carefully support the oven in front of the cutout. Make sure the power to the outlet is turned off and that the warming oven power switch is set to the "OFF" position.
•Plug the power supply cord into the grounded outlet.
•Slide the oven into the cutout.
•Carefully push against the seal area of the oven front frame and slide the oven completely into the cabinet until the front frame is positioned flush against the cabinet face.
2screws
4.Use two (2) screws provided to secure the warming oven frame to the cabinet.
5.Replace the drawer:
receiving slides
•Align the drawer guides with the receiving slides.
•Push drawer in completely. Gently open and close drawer to ensure it is seated properly on the slides.
6.Refer to the "Use and Care Guide," turn the oven on and check the oven's operation.
5
