Side panel requirements +I-
l/8” (3
mm) tolerance
I t 23-118”
(587 mm) depth
protruding door
lnrtalfatlon
23-716"
(606 mm) depth
flush door
lnstallatlon
I
-(lo67 mm)-b
c
J-l
t
side trim
Refrlgerator 4
c
+
114"
(6
mm)
S/32"
-II-
(4mm)
%
il
1116"
3-314"
(2
mm)
(95 mm)
+
,I ; ;:L,
-
5132"
(4mm)
Side trim spacers
1. Attach three spacers as shown
to the top, middle and bottom
of each side of the refrigerator.
Spacers are required for
ventilation.
side panel
support nailer
. .
2. A side panel support nailer
should be attached to the rear
wall on each side of refrigerator
when 25” (635 mm) depth is
available. If less than 25” (635
mm) depth is available, go to
step 3.
If side panel is not inserted into
side trim, drill six equally-spaced
holes in each side trim.
Do Not drill Into side of
cabinet. Attach side panels to
side trim using six screws on
each side.
Side panel thickness should be
l/2” (13 mm) minimum to prevent
blousing” or warping.
slde -I
panel
wood
support*
-8fde panel
rupport nailer
112” (13 mm)
ride panel
fa recommended
* spacer
e srde trim
\
3. If less than 25” (635 mm) depth
is available, side panel
installation will need to be
completed according to each
site’s restrictions.
One method is to attach side
panel to outside of side trim.
However, this will increase
width required. Drill holes into
side trim. Attach a wood support
to side trim. Attach side panel
to panel support nailer and
wood support. Cover wood
support with a panel piece to
match side panel.
\
notches for
door hinges
1 F toe panel recess
4. Height of side panels depends
on your installation site. Side
panels may need to be notched
to clear door hinges. Side
panels may be cut to match toe
panel recess if desired.
Notch slde panel only after
the Installed helght of the
refrlgerator has been
determlned.
Page 5