ml If you wish to change
. the door handle insert,
slide insert trim into
handle. See Custom panel and
insert dimensions for exact sizes
to cut custom inserts. Insert end
caps into each end of door handle.
Replace refrigerator door handle.
(Some end caps are attached
with screws.)
112
n
Repeat Steps 10 and 11
for the freezer door.
11 Remove two nuts from
one end of the top panel
. frame. Remove end
piece. Slide decorative panel into
panel frame. Replace end piece
using nuts.
Check that
top grille is aligned
with
top trim on cabinet. Use
ten screws to lighten top grille frame
to refrigerator. Check that the power
switch is in the “ON” position.
Attach top grille decorative panel
assembly to the keyhole bracket on
the frame and pull down to secure.
If the top grille decorative panel
does not fit evenly within frame, the
keyhole bracket can be moved side
to side by adjusting the bracket
screws or the decorative panel
bracket can be moved up or down
by adjusting the decorator panel
bracket nuts.
set screws ,
Personal injury Hazard
Reinstall set screws after
door swlng is set.
Failure to so could result in
personal injury.
115.1 Check that doors can
open freely. If not, the
door stops can be
adjusted. Loosen set screw in top
and bottom hinges with Allen
wrench. Determine the door swing
desired. Hold door in that position
and tighten the set screws. The
doors have stops at 90°, 115” and
137O positions. If the door stops
cannot be adjusted to clear
countertops, the countertops may
need to be mitered. (Consult your
builder to adjust countertops.)
El Check the water
. connections at the
bottom of the refrigerator
again for leaking. Any leaking can
cause refrigerator and floor damage.
ml 8 Open both doors. Use
two screws to attach
bottom grille to cabinet.
Loosen the four height adjustment
screws. Adjust the bottom grille to
fill the space from the floor to the
bottom of the cabinet. Tighten
adjustment screws.
(18 Put shelves and bins
. into the refrigerator and
freezer compartments.
Remove protective film from door
frame.
Move the ice maker arm
into the down position.
Set refrigerator and
freezer compartment controls to the
midpoint between “COLD” and
“COLDEST”. Check that the
compressor is operating properly.
Check that all five interior lights and
one exterior light above dispenser
area are working.
/20 Use a drinking glass to
. press ice dispenser bar.
You should hear the
motor and auger operating. Press
the glass against the water
dispenser bar. Dispense and
discard 2 to 3 quarts (1.9 to 2.8
liters) of water to remove air from
system and rinse tank.
To get the most efficient
use from your new
built-in refrigerator, read
your KitchenAid’ Use
and Care Guide. Keep
Ins talla tion Ins true tions
and Guide close to
built-in refrigerator for
easy reference.
Page 10