Replacing the Cutting Burrs
If the cutting burrs are damaged, or have reached the end of their life (usually after grinding 270–360 kg of coffee), they can be replaced easily. Refer to “Service Centers” on page 19 to order a set of replacement burrs.
To Replace the Burrs:
1.Remove the faceplate and burr- shaft assemblies. For instructions, see “Cleaning the Cutting Burrs” steps 1, 2, and 3 on page 14.
2.With a screwdriver, remove the burr from the burr-shaft assembly by turning the two burr-mounting screws counter-clockwise until free.
3.Remove the burr from the motor housing by turning the two burr-mounting screws counter-clockwise until free.
4.Attach the replacement burrs to the burr-shaft assembly and motor housing using the burr-mounting screws. Make certain the cutting surfaces of the burrs face outward, and the burr-mounting screws are tight.
5.Insert the burr-shaft assembly into the motor housing and attach the faceplate assembly. For instructions, see “Cleaning the Cutting Burrs” steps 5–10 on pages 15 and 16.
