KitchenAid 6899552, 883298 dimensions Tools needed, Parts needed, Mobile home installation

f

1” min. - IO-3/8” max. upper chimney height

23-518” lower chimney height

support IP structure

-upper chimney

-lower chimney

/

- canopy

t

24-518” min. -

34-314” max. overall chimney height

I

t

10-l/4” canopy

Important: Observe all governing codes and ordinances.

Proper installation is your responsibility:

l Have a qualified technician install this range hood.

l Comply with installation clearances specified on the serial/rating plate.

Serial/rating plate is located inside the range hood on the rear wall.

Range hood location should be away from strong draft areas, such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. Consult your cooktop/range manufacturer installation instructions before making any cutouts.

Grounded electrical outlet is required. See “Electrical requirements.”

Ductwork must terminate outdoors,

All openings in ceiling and wall where range hood will be installed must be sealed.

Electrical Shock Hazard

It is the customer’s responsibility:

*To contact a qualified electrical installer. *To assure that the electrical installation is

adequate and in conformance with National Electrical Code, ANSVNFPA 70 - latest edition’, and all local codes and ordinances.

Failure to do so could result in fire, electrical shock or other personal injury.

Electrical Shock Hazard

*Take special care cutting holes into ceiling or wall. Electrical wires may be concealed behind the ceiling or wall cover and contact with them could result in electrical shock.

l Locate any electrical circuits that could be affected by the installation of this product and disconnect power circuit.

Failure to do so could result in fire, electrical shock or other personal injury.

Personal Injury Hazard

Reaching over a heated cooking surface should be avoided. To reduce the hazard of being burned, the range hood should extend a minimum of 5 inches out from the bottom of the cabinet.

Reaching over a heated cooking surface could result in a serious burn.

Tools needed:

\

I

24” min. bottom of canopy to cooking surface

cooking surface	8’ min. -
	9’ max.
-f	ceiling
	to floor

36” base cabinet height

- l-1/4” drill bit

caulking gun and

saw

flat

duct tape

allen wrench

Parts needed:

2 U.L.-listed,	l/2” conduit	wall	or roof cap
connectors		metal	ductwork
power supply	cable

Mobile home installation

The installation of range hood must conform to the Manufactured Home Construction and Safety Standards, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280); or when such standard is not applicable, the Standard for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups), ANSI Z225.1/NFPA 501A, or with local codes.

Four-wire power supply must be used and the appliance wiring must be revised. See “Electrical requirements.”

Copies of the standards listed may be obtained from:

	l National Fire Protection Association
	Batterymarch Park
Page 1	Quincy, Massachusetts 02269