3
Tools needed:
■Utility knife
■Needle-nose pliers
■Tape measure
■Flat-bladed screwdriver
■#2 Phillips screwdriver
■Side cutting pliers
■Pencil
■Sandpaper
■Level
■Adjustable wrench that
opens to 1¹⁄₈" (29 mm)
■7 mm socket wrench
■5 mm socket wrench
■5 mm open end or box end
wrench
■Electric or hand drill
■1¹⁄₂" hole saw
■Valve (sized to fit hot water
supply line) with ³⁄₈" male
compression fitting
■Protective floor covering
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Parts supplied:
Located in drawer:
■2 flexible trim pieces (for sides)
■Edge protection
■Hose clamp, screw type
■Washer
■Drain hose support
■Drain hose connector
■Hose clamp, wire type
■11, ⁵⁄₈”long, #8 Phillips head wood screws
■Moisture protection tape
■3, 1”hex head wood screws
■3, ⁹⁄₁₆”washers
INSTALLATION REQUIREMENTSLocation Requirements
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
■Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
■Install the dishwasher as specified in these instructions.
■Have everything you need to properly install dishwasher.
■Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
■This dishwasher is manufactured for indoor use only.
■Install the dishwasher in a cabinet cutout that is level, will hold
weight up to 104 lbs. (47 kg), and is in an area suitable for its
size and use.
Product dimensions
23⁷⁄₁₆"
(59.5 cm)
22⁷⁄₁₆" *
(57 cm)
16³⁄₃₂"
(40.9 cm)
side
attaching
tabs
20¹⁵⁄₃₂"
(52 cm)
drawer open
*If custom wood panels are to be used, the product depth is specified with an
¹¹⁄₁₆" (18 mm) door panel thickness.
NOTE: Product shown with front panels for dimension purposes.
Greatest length from product exit point to hookup (does not
include allowance for drain loop):
■Drain hose 88 ⁹⁄₁₆” (2250 mm): Extension kit available - part
■no. 8194400
■Inlet hose 68 ⁷⁄₈” (1750 mm)
■Power cord 44” (1125 mm)