3.Install the pressure regulator with the arrow pointing up towars the bottom of the burner box and in a position where you can reach the regulator cap.
IMPORTANT: All connections must be
Use only
You will need to determine the fittings required depending on your installation.
Typical flexible connection
1.Apply
2.Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Tighten both adapters.
3.Use a ¹⁵⁄₁₆" combination wrench and channel lock pliers to attach the flexible connector to the adapters. Check that connector is not kinked.
A
B
C
| H |
|
D |
|
|
| E F | G |
A. Gas pressure regulator | E. Use | |
B. Use | F. Adapter |
|
C. Adapter - Must have ½" | G. ½" or ¾" gas pipe | |
male pipe thread | H. Manual gas shutoff valve | |
D. Flexible connector |
|
|
Complete Connection
1.Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.
A
B
A. Closed valve
B. Open valve
2.Test all connections by brushing on an approved noncorrosive
3.Remove surface burner caps and grates from parts package. Align notches in burner caps with pins in burner base. Burner caps should be level when properly positioned. If burner caps are not properly positioned, surface burners will not light.
Place burner grates over burners and caps.
B
A
C
A. Igniter electrode
B. Burner cap
C. Burner base
4.If your cooktop only has surface burners, see “Check Operation of Surface Burners, Grill and Griddle” section in the “Complete Installation” section.
5.If your model was shipped with a grill or griddle, see “Install Grill” or “Install Griddle” section.
Install Grill
(on some models)
1.Remove twist tie and discard. Lift burner assembly out of basin and set aside.
A
A. Burner assembly
2.Place drip tray on bottom of grill basin and slide the tray toward the back so that it is located side to side and against the locating feet of the rear spill guard.
A
B
C
A. Rear spill guard
B. Locating feet
C. Drip tray
10