KitchenAid 9760425A Complete Chimney Support Installation, Make Electrical Connection

3.Attach the extension to the support using the 4 bolts supplied with the extension kit. Tighten bolts securely.

9.Replace the four screws and tighten securely.

A

D

C

B

A. Chimney extension frame

B. Chimney support

C.Bolt

D.Captive threaded insert

Complete Chimney Support Installation

1.Run wire through the 1¹⁄₄" (3.0 cm) electrical hole in the ceiling according to the National Electrical Code or CSA Standards and local codes and ordinances. There must be enough power supply cable from the fused disconnect (or circuit breaker) box to make the connection in the hood’s electrical wiring box.

2.Use caulk to seal all openings.

NOTE: Do not reconnect power until installation is complete.

3.Remove wiring box cover located on the top section of the chimney support.

4.Install a UL- or CSA-listed strain relief in the wiring box so that the screws can be tightened after the chimney support is attached to the ceiling.

5.Lift chimney support into final position, feeding electrical wire through the strain relief.

6.Position the chimney support so that the large end of the keyhole slots are over the ceiling attachment bolts. Then push the chimney support so that the bolts are in the neck of the slots. Tighten bolts securely.

IMPORTANT: The chimney support must be securely attached to the ceiling.

7.Determine the desired length of the chimney support.

8.Remove the four screws and adjust the length of the lower chimney support as needed.

NOTE: This is the only section that can be adjusted.

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Disconnect power.

2.Use twist-on connectors and connect black wires together.

3.Use twist-on connectors and connect white wires together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green ground screw in terminal box.

Failure to do so can result in death or electrical shock.

4.Connect ground wire to green ground screw in terminal box.

A	B
	C

			A. Ground screw connector
			B. Ground wire
			C. Power supply cable
A	5.	Tighten strain relief securely.
	6.	Replace wiring box cover. Tighten screw securely.

A. Screws

8