KitchenAid FRONT-LOADING ELECTRIC DRYER manual Plan VentSystem, Optional exhaust installations

Plan VentSystem

Choose your exhaust installation type

Recommended exhaust installations

Typical installations vent the dryer from the rear of the dryer. Other installations are possible.

	B
	C
	D
A	E
	F
	G
	H
A. Dryer	E. Clamps
B. Elbow	F. Rigid metal or flexible metal vent

C. Wall	G. Vent length necessary to connect
D. Exhaust hood	elbows
	H. Exhaust outlet

Optional exhaust installations

This dryer can be converted to exhaust out the right side, left side, or through the bottom. If you prefer, you may contact your local dealer to have the dryer converted.

WARNING

Fire Hazard

Cover unused exhaust holes with one of the following kits:

279818 (white)

280028 (meteorite)

Contact your local dealer.

Failure to follow these instructions can result in death, fire, electrical shock, or serious injury.

Alternate installations for close clearances

Venting systems come in many varieties. Select the type best for your installation. Two close-clearance installations are shown. Refer to the manufacturer’s instructions.

AB

A. Over-the-top installation (also available with one offset elbow)

B. Periscope installation

NOTE: The following kits for close clearance alternate installations are available for purchase. Please see the “Assistance or Service” section of this manual to order.

■Over-the-Top Installation: Part Number 4396028

■Periscope Installation (For use with dryer vent to wall vent mismatch):

Part Number 4396037 - 0" (0 cm) to 18" (45.72 cm) mismatch

Part Number 4396011 - 18" (45.72 cm) to 29" (73.66 cm) mismatch

Part Number 4396014 - 29" (73.66 cm) to 50" (127 cm) mismatch

Special provisions for mobile home installations

The exhaust vent must be securely fastened to a noncombustible portion of the mobile home structure and must not terminate beneath the mobile home. Terminate the exhaust vent outside.

Determine vent path

■ Select the route that will provide the straightest and most direct path outdoors.

■ Plan the installation to use the fewest number of elbows and turns.

A	B	C	■ When using elbows or making turns, allow as much room as
			possible.
	A. Standard rear offset exhaust installation		■ Bend vent gradually to avoid kinking.
	B. Left or right side exhaust installation
			■ Use the fewest 90° turns possible.
	C. Bottom exhaust installation

15