KitchenAid Instant Hot Hot Water Dispenser installation instructions lower water temperature

Installation Instructions cont.

	13.Connect water supply line	NOTE: If you need to remove tubing,
	from saddle valve to spout copper	push down on collet. Pull tubing out
water supply	tubing with the factory-assembled	of quick-connect fitting.
line	quick-connect fitting. Push water
quick-connect	supply line tubing straight into fitting
	as far as it will go. Pull on tubing.
fitting
	The tubing should not come out
	when properly installed. Turn the
copper	saddle valve handle counterclockwise
tubing	to open water line.

saddle valve

NOTE: Do NOT plug power supply cord into outlet.

14.Turn Temperature Control counterclockwise to “Off” position.

On	15.Push down and turn the
	On/Off Cap clockwise to open spout.
	Hold cap open to fill tank (about 1
	minute). When tank is full, water will
	flow from spout. Release cap.

NOTE: Turn Temperature Control to “Off” position before plugging hot water dispenser into power supply. If tank is empty and thermostat is in an “On” position when the

power supply cord is connected, the heater will overheat causing an unpleasant taste, black specks in the water, and permanent damage to the heater seals.

16.Plug power supply cord into grounded 3-prong outlet.

Turn Temperature Control clockwise to highest position.

Water in tank will reach maximum temperature in approximately

15 minutes.

When water is heating, you may hear gurgling noises coming from the tank. There may also be some spitting or

hot water flow from the faucet. This is normal for the initial heat-up of the dispenser.

Turn Temperature Control to lower temperature setting if you notice vapor or hear boiling noise.

NOTE: Temperature Control controls tank heater, not water delivery. Rotate Temperature Control clockwise to raise water temperature, counterclockwise to

lower water temperature. 9