KitchenAid KBGS274PSS, KBGS364PSS, KBGS292PSS Parts supplied, Parts needed, Materials required

The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the State of California to cause cancer, birth defects, or other reproductive harm, and requires businesses to warn of potential exposure to such substances.

WARNING: This product contains a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

This appliance can cause low-level exposure to some of the substances listed, including benzene, crystalline silica, carbon monoxide, toluene, and soot.

In the State of Massachusetts, the following installation instructions apply:

•Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts.

•If using a ball valve, it shall be a T-handle type.

•A flexible gas connector, when used, must not exceed 3 feet.

Tools and parts needed for Built-in (combustible construction) installations

•level

•small flat-blade screwdriver

•flat-blade screwdriver

•Phillips screwdriver

•tape measure or ruler

•slip-joint pliers

•pipe wrench

•scissors or cutting pliers to remove tiedowns

Materials required:

•gas line shutoff valve

•1/2" male pipe thread nipple for connection to pressure regulator

•L.P. gas-resistant pipe-joint compound

•AGA or CSA design-certified flexible stainless steel appliance connector

[4-5 ft. (1.2-1.5 m)] or rigid gas supply line as needed

•non-corrosive leak detection solution

Parts supplied

•convertible regulator is set for 4" W.C. natural gas

Parts needed

The built-in grills are manufactured for use with natural gas.

To convert to L.P./propane gas, Gas Conversion Kit no. 4396311 must be used. Follow Instructions included with kit.

Location requirements

WARNING

Explosion Hazard

Do not store fuel tank in a garage or indoors.

Do not store grill with fuel tank in a garage or indoors.

Failure to follow these instructions can result in death, explosion, or fire.

WARNING

Fire Hazard

Do not use grill near combustible materials.

Do not store combustible materials near grill.

Doing so can result in death or fire.

Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas.

Do not obstruct flow of combustion and ventilation air.

WARNING

Fire Hazard

Do not install this grill on or near combustible materials.

Doing so can result in death or fire.

Clearance to combustible construction for built-in (combustible construction) grills:

A minimum of 12" (30.5 cm) must be maintained between the grill hood, sides and back and any combustible construction.

Rotisserie

If your model is equipped with a rotisserie, 6" (15.2 cm) minimum clearance on each end is needed for the motor and skewer.

A grounded, 3-prong outlet located to the left of the grill is required. (See “Electrical requirements” section.)

Insulated Jacket

Built-in grill for use in a combustible enclosure, also includes an insulated jacket.

3