INSTALLING THE UNIT IN CABINET
Potential Personal Injury Hazard
. Use both hands to remove oven doors.
. Grasp only the sides of the oven door. Do Not use any portion of the front frames or trim for lifting.
Failbre to properly grasp oven door could result in damage to product or personal injury.
The microwave module and the lower oven door should be removed to decrease the weight of the oven and provide a better hand hold on the oven while lifting it into the cabinet.
To REMOVE DOOR (See Fig. 2) Use caution! Oven door is heavy.
A.Open door completely.
B.Depress finger tab in oven door hinge area. Push tab toward oven, lift tab away from door liner, and slide toward top of oven door. Repeat for other side of door.
C.Close door until approximately 5 inches from fully closed position.
D.Slide door off the hinge arm assemblies.
TC REMOVE MICROWAVE MODULE
1.Remove
2.Loosen module trim by removing 4 screws (2 on each side).
3.Remove module trim by pulling forward until free of latch lever.
4 Remove module stabilizing brackets. Save for reinstallation after module has been returned to oven cabinet.
5.Slide module forward until the module service cord on rear can be unplugged. (Model
6.Complete removal of micrOwave module from oven cabinet.
BE SURE THAT PHENOLIC SPACERS AT EACH SIDE OF OVEN
ARE IN PLACE TO PROVIDE PROPER AIR FLCYvV
BETWEEN CABINET AND OVEN.
When oven has been placed into the cabinet, the bottom trim strip is plac- ed on the lower front edge of the front frame. This is done by loosening the three (3) screws at the bottom of the front frame. Slide the trim strip under the screw heads until the strip meets the lower corners of front frame (see Fig. 3). Tighten screws to hold trim to front frame.
Personal Injury Hazard
Securely fasten wall oven to cabinets using the screws provided (4 screws for a double oven or 2 screws for a single oven). Failure to do so could cause oven to move or tip during use and result in
personal injury.
Secure oven to cabinet with #8 screws provided. Do not overtlghten screws. Edge of front frame should be parallel to cabinet. Disregard any excess screws that are left after all screw holes in front frame have been used.
INSTALL UNWRAPPED OVEN RACKS IN OVEN
Fig. 3
REINSTALL MICROWAVE MODULE
Fieassemble module by reversing procedure being sure to connect all elec- trical plugs and replaclng the stabilizing brackets, Make sure that the module trim is lined up with the lower back corners of control frame when
