MOBILE HOME INSTALLATION
When installed in a mobile home, the installation must conform to the Manufactured Home Construction and Safely Standards, Title 24 CFR, Part 3280 (formerly Ihe Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280).
Copies of the standards listed may be obtained from:
‘Natlonal Fire Protect!on Assoclatlon
Batterymarch Park
Quincy, Massachusetts 02269
UNPACKING THE UNIT
Personal Injury Hazard
More than one person is required to lift or move the oven because of Its welght and size.
Failure to follow these Instructions may result In personal Injury.
The oven should ~YZleft on the carton base until it is ready to put into the cabinet. It is also recommended that the pads over the door(s) be left in place. These precautions will reduce the possibility of damage lo the front of the unit and the bottom of the front frame.
Prlsr to installation, check the electrical service to assure that it agrees with the specifications on the oven serial plate
| To Remove |
| Oven | Rackr |
|
|
|
| ||
Remove all cords, tape, and wire used to hold various parts In position dur- | Slide | rack | forward | until | bar | on back | of | rack | ||
ing shipment. Study all labels and tags and remove those on an exposed | touches first | stop |
|
|
|
|
| |||
Clft | front | of | rack | until | rear | portIon | of | rack | ||
surface after installation, unless instructed to leave them for the owner. | ||||||||||
slides | out | between | front | two | stops |
|
| |||
Remove oven racks from the Inside of the oven and unwrap. Put |
|
| ||||||||
|
|
|
|
|
|
|
|
| ||
to one side while the oven IS being installed in cabinet. Take broiler pan, grid, and any other accessories from the pack- ing on top of the oven and keep them with literature packet In a locatlon where they will be retained for use by the owner.
ELECTRICAL CONNEflION
Electrical Shock Hazard
Disconnect power supply before making any electrical connections.
Failure to do so may result in electrical shock.
Connect the conduit from the oven to the junction box and properly connect to the power supply leads The unit IS now ready to install In cabinet
GROUNDING - THE OVEN MUST BE GROUNDED
Do not work on the oven wiring until the oven has been positively grounded
The oven frame IS grounded through the bare grounding wire Connect the white neutral to the service neutral wire at the junction box.
