Care and Cleaning
WARNING
Injury Hazard
Unplug mixer before touching beaters.
Failure to do so can result in broken bones, cuts or bruises.
•Unplug the stand mixer before cleaning.
•Hand wash the flat beater, dough hook, and wire whip in hot sudsy water, rinse thoroughly, and dry immediately. These parts are not
•The bowl is
•Wipe the stand mixer with a clean damp cloth. Do not use abrasive cleansers or scouring pads and do not immerse the stand mixer in water.
•Wipe the beater shaft frequently, removing any residue that may accumulate.
To Remove the Bowl Support for Cleaning
1.Unplug stand mixer or disconnect power.
2.Remove the mixer base by removing the 3 screws located on the bottom of the mixer. Remove the vent screen and the mixer base.
Screws
3.Remove the nut from the lifter rod located inside the column, then remove the washer and spring. Note the order that they were assembled (the washer goes between the spring and nut).
Nut
4.Loosen the screw holding the bowl clip to the front of the bowl support – it is not necessary to remove the screw all of the way. This allows the bowl support to slide down.
Screw
continued…
13
