KitchenAid®
Double Drawer Dishwasher Custom Door Panel Requirements 7) On the back side of the top drawer custom door panel,
rout a 1⁄4” (6.4 mm) radius around the medallion cutout
previously cut in step #4. The medallion end does not
need to be routed.
8) On the back side of the bottom drawer custom door
panel, rout a 1⁄4” (6.4 mm) radius around the medallion
cutout previously cut in step #5. The medallion end does
not need to be routed.
9) If custom door panel material is not suitable to withstand
damp conditions, seal with a moisture resistant material.
For painted panels, paint all rear edges to improve sealing.
10) On the backside of the top drawer custom door panel,
measure and mark the vertical center line and horizontal
position line (See figure 3A).
NOTE: The 1 7⁄16” (36.5 mm) horizontal position line is
marked for later use in the installation process. Refer to
the Installation Instructions Drawer Dishwasher included
with the Drawer Dishwasher to align and attach the top
drawer custom door panel to the factory supplied
metal plate.
11) On the backside of the bottom drawer custom door
panel, measure and mark the vertical center line and
horizontal position line (See figure 3B).
NOTE: The 1 3⁄16” (30.2 mm) horizontal position line is
marked for later use in the installation process. Refer to
the Installation Instructions Drawer Dishwasher included
with the Drawer Dishwasher to align and attach the
bottom drawer custom door panel to the factory supplied
metal plate.
12) Mount the customer supplied handles to the locations
previously marked on the top and bottom drawer
custom panels.
IMPORTANT: When mounting the customer supplied
handles, screws must fit flush to the panel and not extend
beyond the back surface.
13) Refer to the Installation Instructions Drawer
Dishwasher included with the Drawer Dishwasher
to complete installation.
1 7⁄16”
(36.5 mm)
Vertical
Center Line Medallion
Location Area
FIGURE 3A
Horizontal
Position Line
CUSTOM
PANEL FOR
TOP DRAWER
(Back Side)
MODELS: KUDD01DPPA
1 3⁄16”
(30.2 mm)
Vertical
Center Line
Medallion
Location Area
FIGURE 3B
Horizontal
Position Line