Rinse Aid Dispenser
Rinse aids prevent water from forming droplets that can dry as spots or streaks. They also improve drying by allowing water to drain off of the dishes during the final rinse by releasing a small amount of the rinse aid into the rinse water. Your dishwasher is designed to use a liquid rinse aid. Do not use a solid or
Dishwasher Efficiency Tips
Hot water dissolves and activates the dishwashing detergent. Hot water also dissolves grease on dishes and helps glasses dry
Filling the dispenser
The rinse aid dispenser holds 4.8 oz (145 mL) of rinse aid. Under normal conditions, this will last for about three months. You do not have to wait until the dispenser is empty to refill it. Try to keep it full, but be careful not to overfill it.
1.Make sure the dishwasher door is fully open.
2.Open the dispenser by pushing the cover latch.
1
3
2 
1.Cover latch
2.Rinse aid dispenser
3.Indicator window
3.Add rinse aid until the indicator window looks full.
4.Clean up any spilled rinse aid with a damp cloth.
5.Close the cover.
NOTE: The cover latch clicks when the cover is closed and latched.
Rinse aid setting
The amount of rinse aid released into the final wash can be adjusted. The factory setting is at 2. For most water conditions, set the adjuster to 1 or 2. If there are rings or calcium (hard water) spots on dishes, try a higher setting.
To adjust the setting
Open the dispenser cover. Turn the adjuster inside the dispenser to the desired setting.
To check water temperature
1.Run hot water at the faucet closest to your dishwasher for at least 1 minute.
2.Place a candy or meat thermometer in a glass measuring cup.
3.Check the temperature on the thermometer as the water is running into the cup.
4.If the water temperature at the faucet is below 120°F (49°C), have a qualified person raise the water heater’s thermostat setting.
■To save water, energy and time, do not rinse dishes before putting them into the dishwasher.
■Use the Normal cycle whenever possible. This cycle uses less hot water and energy than other cycles.
■Use a delay feature (on some models) to run your dishwasher during
■During the summer, run your dishwasher at night. This reduces daytime heat buildup in the kitchen.
■Use an air dry, or an
■Use cycles or options that add extra heat to the wash or rinse portion of the cycle only when needed.
■Run your dishwasher with full loads. Run a rinse cycle after meals until the dishwasher is full.
■If your home is equipped with a water softener, you may want to avoid starting the dishwasher during the regeneration of the softener, as this may contribute to poor wash performance.
10
