KitchenAid KUDR01TJ Changing a Cycle or Setting, Adding Items During a Cycle, Canceling a Cycle

Use this cycle for a quick wash

and light dry to cleanup

cookware prior to entertaining.

Use main

The sensor adds water and

time to the cycle, if needed, for

detergent

maximum cleaning. This cycle

dispenser

uses a shortened dry time.

section.

Towel drying may be needed.

Water

Rinse

Main

Rinse

Final

Dry

Time

Water

Temp

Wash

Heated

(min)

Usage

Sensed

Rinse

(gal/L)

Hot

●

●

●

●

44*

5.2-6.5

/20-25

Cold

●

●

●

●

●

48*

7.1-8.2/

27-31

Use this rinse cycle for

rinsing dishes, glasses, and

silverware that will not be

Do not use

washed right away.

detergent with this

cycle.

Soil

Pre-

Main

Rinse

Rinse

Final

Dry

Time

Water

Level

Wash

Wash

Heated

(min)

Usage

Sensed

Rinse

(gal/L)

●

10

1.8/7

†A small amount of water is run through the pump to remove soil particles between the main wash and final rinse.

NOTES:

■The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary from the numbers above as the sensor adjusts the cycle for the best wash performance.

■In the Normal cycle, the dishwasher pauses while soaking. Soaking helps loosen soils on dishes for brilliant results.

Changing a Cycle or Setting

During the first minute of a cycle

Press a new cycle and/or options.

After the first minute of a cycle

1.Press

CANCEL/DRAIN glows. The dishwasher starts a 2 minute drain (if needed). Let the dishwasher drain completely.

2.Check the detergent dispensers. If the main wash cup has opened and the detergent washed away, refill the cups as needed.

3.Close the door.

4.Press a new cycle and/or options.

5.Press START.

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open the door and check the detergent dispenser. If the cover is still closed, you can add items.

To add items

1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.

2.Open the door. If the detergent dispenser cover is still closed, add the item.

3.Close the door firmly until it latches. The dishwasher resumes the cycle after about a 5 second pause.

Canceling a Cycle

Anytime during a cycle, press

CANCEL/DRAIN glows. The dishwasher starts a 2 minute drain (if needed). Let the dishwasher drain completely. The light goes off when the dishwasher finishes the drain.

To stop the drain

You can press Cancel/Drain again to stop the drain immediately. Remember to drain the dishwasher before starting a new cycle.

To clear the indicators

Press Cancel/Drain before starting the dishwasher to clear all options and cycles.

Option Selections

You can customize your cycles by pressing an option. If you change your mind, press the option again to turn the option off. Select a different option if desired.

You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.

Press START to repeat the same cycle and options as the previous wash cycle.

NOTE: If the last cycle you completed was a rinse cycle, when you press Start, the dishwasher runs the last full wash cycle and options.

Hi-Temp Scrub

Select this option to heat the water during parts of the cycle, and add a rinse. Higher water temperatures and an extra rinse helps clean tough soil. Hi-Temp Scrub, with the Heavy cycle, raises the water temperature in the main wash and the prewash. Hi-Temp Scrub, with the Normal cycle, raises the water temperature in the main wash.

This option adds heat, water and wash time to the cycle.

NOTE: Hi-Temp Scrub is an option with the Heavy and Normal cycles.

12