InstallVent System
WARNING
Excessive Weight Hazard
Use two or more people to move and install dryer. Failure to do so can result in back or other injury.
1.Position the dryer so that the rear of the dryer is within 4 ft (1.2 m) of its final location.
2.Install exhaust hood. Use caulking compound to seal exterior wall opening around exhaust hood.
3.Connect vent to exhaust hood. Vent must fit inside exhaust hood. Secure vent to exhaust hood with 4" (10.2 cm) clamp.
4.Run vent to dryer location. Use the straightest path possible. See “Determine vent path” in “Plan Vent System.” Avoid 90º turns. Use clamps to seal all joints. Do not use duct tape, screws or other fastening devices that extend into the interior of the vent to secure vent.
Connect Vent
1.Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Check that the vent is secured to exhaust hood with a 4" (10.2 cm) clamp.
2.Move dryer into its final location. Do not crush or kink vent.
Level Dryer
All four dryer feet were preset to the same height at the factory.
1.Using a ⁹⁄₁₆" (14 mm)
2.Slide the dryer to its final location.
3.Check the levelness of the dryer. Check levelness first side to side, then front to back.
4.If the dryer is not level, move the dryer slightly away from the wall and first prop the front with a wood block and adjust the feet as necessary; then prop the back and adjust feet as necessary. Repeat this step until dryer is level.
5.After the dryer is level, use a ⁹⁄₁₆" (14 mm)
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all of your tools.
3.Check the dryer’s final location. Be sure the vent is not crushed or kinked.
4.Check that the dryer is level. See “Level Dryer.”
5.For power supply cord installation, plug into a grounded outlet. For direct wire installation, turn on power.
6.Remove any protective film or tape remaining on the dryer.
7.Dispose of/recycle all packaging materials.
8.Set the decorative mat in place on top of the dryer, if desired. NOTE: Check that the top of the dryer and the bottom of the mat are clean.
9.Read “Dryer Use.”
10.Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.
11.Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.
If the dryer will not start, check the following:
■Controls are set in a running or “On” position.
■Start button has been pushed firmly.
■Dryer is plugged into a grounded outlet and/or electrical supply is on.
■Household fuse is intact and tight, or circuit breaker has not tripped.
■Dryer door is closed.
12.When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you feel heat, cancel cycle and close the door.
If you do not feel heat, turn off the dryer and check the following:
■There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. If there is still no heat, contact a qualified technician.
NOTE: You may notice a burning odor when the dryer is first heated. This odor is common when the heating element is first used. The odor will go away.
15
