Installation Instructions...
•As with all metal objects, follow proper handling techniques.
•The sink installation must comply with national and local plumbing codes and ordinances
•This sink should be examined for damage prior to installation. Do not install a damaged sink. Return the sink to the dealer from whom you purchased it. Failure to do so will void the warranty.
Clamp positions
All provided clamps have two positions.
The install position refers to the position of the hardware, as it is attached or attaches to the sink, when the claw portion is NOT pointed to the outer edges of the sink rim. This position allows the sink to fit through the countertop opening.
The mount position refers to the hardware, as it is attached or attaches to the sink, with the claw portion pointed toward the outer edges of the sink rim. This position allows the sink to be clamped to the countertop via the claws.
Installing in countertop
Prepare countertop:
1. Locate template in sink package (NOTE: If no template
is provided contact KitchenAid, see “Requesting Assistance or Service” section). Set template on countertop surface in desired position. Hold template down firmly and trace around the template with a pencil onto the countertop. Remove the template.
2. Drill a 3/8” pilot hole on the inside edge of the line that was traced onto the countertop. Set jigsaw blade into the pilot hole and cut along the outline traced on the countertop.
Prepare the sink:
3. Remove any protective film, plastic bag and/or tape from the sink.
Install hardware:
4. Assemble clamps, attach the assembled clamps to the sink in their install positions (claws resting against sink or pointing away from the countertop).
Check sink fit/adjust:
5. Set the sink into the countertop opening in the desired position (see Figure 1). The countertop opening may need to be adjusted for the sink. Proper fit may be accomplished with the jigsaw and /or file. Care should be taken not to chip or crack the countertop material by aggressive filing or sawing. The sink rim should rest evenly on the countertop. Remove sink, turn upside down and proceed to step 6.
Figure 1 |
Sink |
Countertop |
Install sink:
6. Place a continuous bead of silicone sealant around the entire perimeter of the sink rim. Lift the sink, turn it right side up, and lower back into the countertop cutout opening in the desired position (see Figure 1). Move all clamps to their mount positions (claws pointing away from the sink under the countertop). Begin tightening clips (see Figure 2) but do not overtighten. It is only necessary to draw the sink rim down firmly to the countertop. Tighten until the entire sink rim is sealed. Wipe off any excess sealant from the countertop with a dry cloth.
Figure 2
1 |
|
|
| 2 |
7 |
|
| 8 |
6 | 3 | 4 | 5 |
Tighten clamps gradually, in a sequence similar to that shown.
3
