5.Cut the 1¹⁄₂" (3.8 cm) diameter hole at the circular shaded area “G” on the template. This hole is for the power supply cord.
NOTE: If upper cabinet is metal, the supply cord bushing needs to be installed around the supply cord hole, as shown.
B
A
A. Metal cabinet
B. Power supply cord bushing
6.Drill 3/8" (10 mm) holes at points “D” and “E” on the template. These are for two
For Roof Venting Installation Only
7.Cut 3/4" (19 mm) hole at one corner of the shaded rectangular area “F” on Upper Cabinet Template.
8.Using a keyhole saw, cut out the rectangular area.
Install the Microwave Oven
WARNING
Excessive Weight Hazard
Use two or more people to move and install microwave oven.
Failure to do so can result in back or other injury.
IMPORTANT: The right side of the microwave oven is the heavy side. Handle the microwave oven gently.
1.Place a washer on each
2.Make sure the microwave oven door is closed and taped shut.
3.Using 2 or more people, lift microwave oven and hang it on support tabs at the bottom of mounting plate.
NOTE: To avoid damage to the microwave oven, do not grip or use the door or door handle while the microwave oven is being handled.
A |
B |
A. Mounting plate
B. Support tabs
4.With front of microwave oven still tilted, thread power supply cord through the power supply cord hole in the bottom of the upper cabinet.
5.Rotate microwave oven up toward upper cabinet.
NOTE: If venting through the wall, make sure the damper assembly fits easily into the vent in the wall cutout.
6.Push microwave oven against mounting plate and hold in place.
NOTE: If microwave oven does not need to be adjusted, skip steps
7.If adjustment is required, rotate microwave oven downward. Using 2 or more people, lift microwave oven off of mounting plate, and set aside on a protected surface.
8.Loosen mounting plate screws. Adjust mounting plate and retighten screws.
9.Repeat steps
10.With the microwave oven centered, and with at least one person holding it in place, insert bolts through upper cabinet into microwave oven. Tighten bolts until there is no gap between upper cabinet and microwave oven.
NOTES:
■Some upper cabinets may require bolts longer or shorter than 3" (7.6 cm). Longer or shorter bolts are available at most hardware stores.
■Overtightening bolts may warp the top of the microwave oven. To avoid warping, wood filler blocks may be added. The blocks must be the same thickness as the space between the upper cabinet bottom and the microwave oven.
A
A.
9
