INSTALLATION INSTRUCTIONS
Remove Mounting Plate
NOTE: To avoid possible damage to the work surface, cover the work surface.
1.Remove any remaining contents from the microwave oven cavity.
2.Remove the mounting plate by peeling off the strips of tape that attach it to the back of the microwave oven, and set the mounting plate aside.
ABC
A. Mounting plate
B. Back of microwave oven
C. Tape (multiple locations)
3.Tape the microwave oven door closed so that door does not swing open while the microwave oven is being handled.
NOTE: To avoid damage to the microwave oven, do not grip or use the door or door handle while the microwave oven is being handled.
Convert Microwave Oven to
External Venting
(for wall or roof venting only)
The microwave oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. See “Venting Design Specifications” section.
NOTE: Skip this section if you are using recirculation installation. Keep the damper assembly in case the venting method is changed, or the microwave oven is reinstalled in another location where wall or roof venting may be used.
To prepare the microwave oven for wall or roof venting, the vent deflector
To Install Vent Deflector:
1.Gently pull the rings and lift vent screen from the top of the microwave oven.
A
BC
A.Top of microwave oven
B.Vent screen
C.Rings
2.With vent deflector oriented as shown (wide side down), slide it back and under the back edge of the vent opening.
A B
A. Vent opening B. Vent deflector
4
